MSD Blaster II Series high performance ignition coil in red, supplied with ballast resistor, MSD's famous red canister coil! If your application uses a points distributor, the ballast resistor must be used, most late-model electronic ignitions, including MSD ignitions, don't require the resistor.
If you are looking to upgrade your stock coil, or want to compliment the performance of your MSD Blaster ignition from MSD's 5, 6, or 7 series, the Blaster coil line is the right choice. Our Blaster coils are designed for improved spark output, with special 100:1 windings, used to provide maximum build-up of voltage!
These windings are held secure and kept cool in an oil-filled metal canister. The Blaster coil is designed to mount in most factory canister coil mounts, but MSD do offer a chrome coil bracket, PN 8213 if required and it is recommended to mount the PN 8202, 82023 and 8223 coils, in an upright position.
Features:
Improved output coil for electronic ignitions, Blaster ignition or MSD 5, 6 and 7 SeriesSupplied with two spark plug wire boots, terminals and ballast resistor (required with stock points ignition)Alkyd tower with high dielectric properties is less prone to carbon tracking100:1 turns ratio and lower primary resistance produce high voltage outputMSD red metal canister is filled with a premium grade oil for coolingCARB E.O. approved
This part is legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles.
The following vehicles are considered Uncontrolled (Non-Emissions Controlled) Vehicles:
- 1965 and older U.S. manufactured California Certified vehicles
- 1967 and older U.S. manufactured Federally Certified vehicles
- 1967 and older Foreign manufactured vehicle
WARNING: It is against the law to install this part on an Emissions Controlled Vehicle
The following vehicles are considered Emissions Controlled Vehicles:
1966 and newer U.S. manufactured California Certified vehicles1968 and newer U.S. manufactured Federally Certified vehicles1968 and newer Foreign manufactured vehicle
.jpg)
