NEO Synthetics HP 800 multi purpose grease, designed for use in for plain and rolling element bearings as well as sliding mechanisms operating in generally difficult conditions. Exceptionally resistant to water wash out, including emulsions, NEO HP 800 was designed specifically for precision rolling element bearings in high performance racing cars.
This grease is slightly thinner in consistency and has a higher viscosity synthetic fluid incorporated in it's design when compared to greases normally used for passenger vehicle. Designed to lubricate to 425°C (800°F).
NEO HP800 is designed for the peripheral speeds encountered by wheel bearings in racing which are 3 to 6 times that of passenger cars and prevent channeling of the grease under these conditions which requires a lighter consistency product.
Due to the excessive heat generated by over-sized disk brakes, the fluid constituent of the grease is synthetic and of a higher viscosity so as to provide the proper oil viscosity at operating temperature, thereby preventing thin film rupture, and excessive wear.
Special additive technology and synthetic fluids give high film strength under EP conditions with exceptional oxidative and thermal stability. Can be used on sensitive metallurgy including copper, silver, tin, aluminum, and their alloys.
Highly specialized mixed base complex soap structure provides high dropping point, mechanical and thermal stability. Low bleed characteristics insure protection at high temperature and high radial forces.
Ideal for use in high temperature lubricated packing boxes, hot and cold rolling mills, slabbing mills, ladle pins, continuous casting wheels, converter bearings, overhead conveyor bearings; also bushings, bearings, and cutter head mechanisms on continuous mining machines.
Unexcelled for high speed, highly loaded couplings and splines found in steel mill operations. NLGI grade 1 1/2 designed for grease lubricated roll neck bearings and automatic grease dispensing systems.
Available in jars, cartridges or tubes
Specifications:NLGI grade 1 1/2 classificationPenetration at 60 strokes 292100,000 strokes 308Percent change 4.4%Dropping point: Less than 600°FModified drop test (in house) 800°FEvaporation wt. loss at 250°F, 24hr 0.045%Copper corrosion at 212°F 3hrs 1 lb4-Ball EP weld load 350KgOil viscosity at 100°F 2500 SUSAt 210 degree F 210 SUSBase oil, ISO VG grade 1000Pour point: 30°FFlash point: 577°FTimken OK load 60 lbs